The use skills and maintenance of the break-in time of the hydraulic hammer are very critical. The hammer usually has a break-in time of about 60 hours after leaving the factory. The break-in time is a key step to reduce the failure rate of equipment, ensure the normal operation of the facility, and increase the service life of the facility. Let's take a look at the maintenance and use skills of this product during the break-in period.
1. Pay attention to the running load during the running-in period. The running load during the running-in period is usually not higher than 80% of the rated running load.
2. Pay attention to the signs and abnormal conditions of the instrument panel frequently. If there is a common fault, the disassembly and assembly should be terminated as soon as possible, and the use should be terminated before the common fault is dealt with.
3. Because the hydraulic hammer is a special equipment, the employees should accept the professional training and specific guidance of the manufacturer before operation, fully grasp the structural characteristics and characteristics of the equipment, and obtain the corresponding use and maintenance work experience. The goods brought by the manufacturer The application and maintenance guide is the essential data information for the user to use the facility. Before using the equipment, the user must read the application and maintenance guide first, and complete the use and maintenance according to the standard of the guide.
4. Pay attention to check the level and quality of grease, hydraulic oil, inspection, brake fluid and fuel (water), and pay attention to check the airtightness of the whole machine. If you find that there is less oil and water during the inspection, you should analyze the reasons and strengthen each Lubrication of lubricating points. During the break-in period, go to the lubricating points to supply oil as much as possible during each shift.
5. Maintain the cleaning of the gun hammer, adjust and tighten the loose components as soon as possible to prevent damage to the weighted components or loss of components due to loosening.
6. After the operation cycle time is completed, the equipment should be maintained for the cycle time, regularly check and adjust, and pay attention to changing the oil.
The above is the application and maintenance method of hydraulic hammer in the running-in time. For all facilities, the running-in time is a very critical stage. The running-in period of this stage has a great impact on the future application of the facility.
