Hydraulic hammers are widely used in engineering projects and play a particularly critical role in crushing work. Breakers are often used to replace excavator work, but they must strictly follow safe operation procedures when disassembling and assembling. We will explain to you below. Reasonable disassembly and assembly method of the lower breaker and how to place it when it is not used for a long time.
1. Disassembly method:
(1) Move the gun hammer from the muddy, dusty and dirty position to a stable and firm road, turn off the engine and the main switch, and release the air when the pressure in the oil tank is high;
(2) Turn the stop valve (installed on the arm end) 90 degrees to the "off" position to avoid hydraulic oil discharge;
(3) Loosen the hose connection on the barrel arm;
(4) Be careful not to let silt and dust enter the oil pipeline, plug the rubber hose with a bottle stopper, and connect the pipeline with a connecting pipe;
(5) Remove the crusher and connect the bucket and arm with pins. If the circuit breaker is placed outside, place it on a board and cover with a protective film.
2, hydraulic hammer placement method:
(1) Clear the outside of the hammer first;
(2) Remove the drilling tool, apply rust inhibitor, put it in place, release N2 first, and then send the piston rod into the oil cylinder;
(3) After adding lubricating oil to each position of the gun hammer, put the drill back. From then on, it can be stored and stored.
If you want to reinstall the hammer for use, unload the procedure in the opposite direction. Because the hoses and pipelines are contaminated with smoke and dust after the operation machine performs other work, the hydraulic pipelines and joints need to be cleaned before the replacement work. tidy.
The above is a reasonable way to dismantle the hydraulic hammer. The operator can use reasonable operation steps to put the breaker dismantling device to the corresponding level to ensure the working efficiency of the breaker and increase the service life of the breaker at the corresponding level.
