Hydraulic HammerIt is widely used in engineering project operations and plays a very important role in some crushing work. Breakers are often used to replace excavators, but they should be strictly operated in accordance with the safety operating procedures during disassembly and assembly. The following editor will introduce to you Reasonable disassembly and assembly method of the lower breaker and how to place it when it is not used for a long time.
1. Disassembly method:
(1) Move the hydraulic gun hammer from the mud, dust and dirty parts to a stable and firm floor, turn off the engine and the main switch, and release the air when the pressure in the fuel tank is high;
(2) Turn the stop valve (installed on the arm end) by 90 degrees to the "off" position to avoid hydraulic oil discharge;
(3) Loosen the hose connection on the barrel arm;
(4) Be careful not to let silt and dust enter the oil pipeline, block the hose with a bottle stopper, and connect the pipeline with a connecting pipe;
(5) Remove the crusher and connect the bucket and arm with pins. If the circuit breaker is placed outside, put it on a board and cover the protective film.
2, Placement method:
(1) Clear the outside of the hammer first;
(2) Remove the drilling tool, apply anti-rust oil, put it in the original place, release N2 first, and then send the piston into the cylinder;
(3) After adding lubricating oil to each part of the hydraulic hammer, put the drilling tool back. Where can it be stored and stored.
If you want to reinstall the hydraulic hammer for actual operation, reverse the unloading procedure. Because the hoses and pipelines are polluted by dust after other work is performed on the operating equipment, the hydraulic pipelines and each joint need to be removed before the replacement work. Clean and tidy.
The above is a reasonable way to dismantle the hydraulic hammer. The operator can apply the reasonable operation steps to put the breaker dismantling device to a corresponding level, so as to ensure the working efficiency of the breaker and prolong the service life of the breaker to a corresponding extent.
