Control of the strike force of the breaker

2021-06-16

LargeHammerThe source of the driving force is the pressure oil brought by the pump station of the excavator or loader, which can better remove the floating stones and the sand in the gap of the rock formation in the role of excavating the foundation of the house. It will make the force of the severe blow not fully stimulated; at the same time, the severe blow force of the breaker will shock back to the breaker itself, the guard plate and the use arm of the construction machine itself, etc., resulting in the destruction of the above components. How should you use it? How to increase the severity of Yantai breaker? Pay attention to the following aspects.

1. Do not use the breaker to promote hanging objects or large rock formations

Do not use the guard plate as a tool to promote hanging objects during work, so it always leads to the cracking of the guard plate screws and drill rods, damage to the breaker, and even the root cause of the breakage of the heavy arm.

2. Prevent the large breaker from emptying under the condition of no target.

When the rock formation or the target object has been destroyed, please stop the severe attack of the breaker immediately. Constant and aimless interference will always cause the screw of the precursor and the main body to fall off and damage, and even damage the construction machinery and equipment.

3. Preparation before crushing

When the high-pressure or low-pressure plastic hose of the breaker falls off too much, please stop the operation immediately and check and repair it in time.

4. Pay attention to the use of large breakers

When running the crushing work, please make sure that the position of the drill rod's impact point and the surface of the crushed object are vertical, and try to maintain it anytime and anywhere; if the surface of the crushed object is skewed, the drill rod may slip from the surface. Open, in this case, it may cause the drill rod to be damaged and interfere with the piston rod. When crushing, please select a reasonable severe blow point first. After confirming that the drill rod is indeed firm, carry out severe blow.