Banner

行业知识

Home>Industry knowledge>Content

Lubrication requirements of breaker

2020-10-09

As a device with a wide range of use and a relatively high frequency of use,HammerThe inspection and maintenance work is particularly important. After all, only by keeping the equipment in good condition at all times can it play a better role when used, the construction efficiency will be higher, and the service life will be longer. In terms of equipment maintenance, lubrication is a very important part, and it can even be said that it has a vital impact on the life of the equipment. The following editor will briefly talk about the requirements of the breaker in the lubrication work, I hope it can be helpful to you.

Unlike most preventive maintenance work (measured every few hundred hours), the lubricator of the breaker needs to be lubricated every day, even several times a day. According to industry standards, the lubrication frequency is every two hours. Of course, If we inspect the equipment regularly, the lubrication interval may be shorter. During the inspection, it is necessary to observe whether the grease leaks from the tip of the tool. Once the seepage stops, the equipment needs to be lubricated.

In the process of lifting the breaker, there will be a circle of paste three to four inches below the tool shaft housing. If not, it means that there is insufficient grease and manual lubrication is required.

Manual lubrication is actually a relatively tedious task, which is troublesome and sometimes forgotten, so an automatic lubrication system appeared, which can be installed on the circuit breaker to ensure timely supply of grease. In addition, it can also be installed on the support and connected with the breaker by pipeline.

The breaker needs to choose a suitable bracket during use. Only when the circuit breaker and the bracket match each other, the operation of the system on the bracket will be very smooth.

破碎锤

The method of improving the striking force of large breaking hammer

The reason why the excavator breaker does not absorb oil and the failure that will occur in a short time