Precautions when operating the breaker

2020-09-01

The breaker is an indispensable part in the crushing operation, which can improve work efficiency and liberate manpower to a great extent, but there are also many precautions during the operation of the breaker.Breaker manufacturersLet me talk to you about the matters needing attention when operating the breaker.

1. Do not hit continuously for more than 1 minute

When hitting hard rocks, do not hit the same place for more than 1 minute. Long-term hitting operation will cause the oil temperature to rise, which will cause damage to the steel drill bushing and progress wear of the steel drill.

2. The operation should be stopped when the hose vibrates severely

It is necessary to check whether the high-pressure and low-pressure hoses of the breaker vibrate too violently. If that is the case, you should immediately contact the local authorized and designated service office to allow professionals to overhaul the equipment. Also check the hose joints for the first time. There is no oil leakage. If there is oil leakage, you need to re-tighten the joint.

3. The steel drill can not be used as a crowbar

Hammer manufacturers believe that if steel drills are used as pry bars when crushing rocks, bolts and steel drills may break.

4. Avoid excessive air strikes

Once the stone is broken, the hammer should be stopped immediately. If the air strike continues, the bolt will loosen or break; when the breaking hammer has improper penetration force or the steel drill is used as a pry bar, the air strike will also occur.

5. Don't hang objects with a breaker

Do not use ropes to suspend objects on the breaker, it is easy to damage the breaker, and this operation is also dangerous.

The above are the several problems that the broken hammer manufacturers need to pay attention to during the operation of the broken hammer. As a very important and easily damaged part, the use of the broken hammer must be cautious and cautious. Don't cause it because of negligence. Equipment damage.